Electrical Test Equipment For Substation & Protection Relay Testing
Products: Secondary Injection: UNO
Complete single phase two reversible channels.
The UNO is a comprehensive, portable Single-phase test system capable of testing all types of single phase protective relays.
The system comprises 2 independent units (PTE-50-CE & PTE-100-V) with independent output channels.
Each output channel is reversible from Voltage to Current (in the Voltage unit) or from Current to Voltage (in the Current unit).
Each output is controlled for Amplitude and Phase Angle and can be ‘linked’ into a Master-Slave coordinated sequence, with simulated ramp and dynamic changes.
All output signals are digitally generated, amplified, and internally controlled by the IGM’s (Intelligent Generator Modules) which interpret the commands received from the front panel to produce a highly accurate and stable output with low distortion that is independent of the voltage supply.
CHARACTERISTICS
Complete Single phase system supplied in 2 units (PTE-50-CE/PTE-100-V).
Reversible Outputs (Up to 2 current and 2 Voltage Outputs).
Single phase current output 50A or 150V.
Single phase voltage output 300V or 8A.
Variable phase angle from 0°-360°, independent in each output channel.
Variable frequency between 40 to 420 Hz.
Programmable frequency ramp, with selectable ramp speed between 0.01 Hz/s. to 10 Hz/s.
Instantaneous Frequency Step from one value to another.
Harmonic Selection, independent in each current phase to the 7th harmonic.
Output power is 100 VA in each channel.
Fully isolated outputs.
Manual Control of all outputs and phase angles, independent in each channel.
Fault Simulation can be programmed and achieved manually on the front panel controls.
Capability to perform dynamic and transient tests with a bandwidth of 0.5 to 5000 Hz.
Completely programmable from a computer.
Close Case Calibration.
Built-in timer with reading in seconds or cycles.
3 independent monitors.
External phase and frequency reference.
Case: IP-65.
Portable.
All right reserved
www.technopowereg.com
UNO Applications:
DEVICE IEEE |
Relay Type |
2 |
Time-Delay Starting Relay |
21 |
Distance 1Ø |
21 |
Distance (open triangle) |
21 |
Distance 3Ø |
24 |
Volts / Hertz |
25 |
Synchronizing |
27 |
Undervoltage Relay AC/DC |
32 |
Directional Power Relay 1Ø |
40 |
Loss of Field Relay |
46 |
Reverse Phase Relay |
46N |
Negative Sequence Overcurrent Relay |
47 |
Reverse Phase Relay-Voltage |
49 |
Thermal Relay |
50 |
Instantaneous Overcurrent Relay |
51 |
Overcurrent Relay AC |
55 |
Power Factor Relay |
59 |
Overvoltage Relay |
64 |
Ground Detection Relay |
67 |
Directional Overcurrent Relay |
67N |
Ground Directional Overcurrent Relay |
78 |
Phase Angle measuring or Out of Step Protective Relay |
79 |
Reclosing Relays |
81 |
Frequency Relay |
85 |
Carrier or Pilot Wire Relay |
87 |
Differential Relay |
91 |
Voltage Directional Relay |
92 |
Voltage and Power Directional Relay |
94 |
Tripping Relay |